Oven displays error F101 or F102 and cannot set any functions

Q: Oven displays error F101 or F102 and cannot set any functions

F101, F102 - Door lock sensor fault Check that the door is fully closed Restart the appliance and check that it works correctly after restarting. Note: To restart the appliance, disconnect it from the mains and wait at least 30 seconds before switching it back on. In the case of built-in appliances, it is unnecessary to disconnect the cable physically - the appliance can be disconnected using the household RCD breaker. Contact an Authorized Service Centre. If the above steps don't resolve the issue, we recommend contacting an Authorized Service Center. AEG Book a Service Electrolux Book a Service

Question

Accepted Answer

F101, F102 - Door lock sensor fault

Check that the door is fully closed
Restart the appliance and check that it works correctly after restarting.

Note: To restart the appliance, disconnect it from the mains and wait at least 30 seconds before switching it back on.

In the case of built-in appliances, it is unnecessary to disconnect the cable physically - the appliance can be disconnected using the household RCD breaker.

Contact an Authorized Service Centre.

If the above steps don't resolve the issue, we recommend contacting an Authorized Service Center.

AEG Book a Service

Electrolux Book a Service

Oven displays error F101 or F102

Issue

Applies to

Solution

Was this article helpful?