Microwave Error message F240, F439, F908, F131

Issue

Built-in Combination Microwave oven displays and Error code.

Applies to

• Microwave Cobmination Oven

Solution

How to manage: Error codes

When a system error occurs, the display shows error message.

Microwave Error message

F240, F439 - The touch fields on the display do not work properly.

Clean the surface of the display. Make sure there is no dirt on the touch fields.

F908 - The appliance system cannot connect with the control panel.

Restart the appliance and check that it works correctly after switching it back on.

Note: To restart the appliance, disconnect it from the mains and wait at least 30 seconds before switching it back on.

In the case of built-in appliances, it is unnecessary to disconnect the cable physically - the appliance can be disconnected using the household RCD breaker.

F131 - The temperature of magnetron sensor is too high.

Turn the appliance off and wait until it cools down. Turn the appliance on again.

Contact an Authorized Service Centre.

If the above steps don't resolve the issue, we recommend contacting an Authorized Service Centre.