Oven displays error F239
Issue
Oven displays error F239
Applies to
- Built-In Oven
Solution
F239 – Indicates: Touch board alarm.
- Restart the appliance and check that it works correctly after switching it back on.
Note: To restart the appliance, disconnect it from the mains and wait at least 30 seconds before switching it back on.
In the case of built-in appliances, it is unnecessary to disconnect the cable physically - the appliance can be disconnected using the household RCD breaker.
Contact an Authorized Service Centre.
If the above steps don't resolve the issue, we recommend contacting an Authorized Service Center.
AEG Book a Service
Electrolux Book a Service
Was this article helpful?
Related Articles
- Oven displays error F908, F113
- Microwave - the interior light is not working lamp replacement instructions
- The cooker hood is dripping water
- Oven light does not work
- Stains or marks on SaphirMatt cooktop – Cleaning advice
- Burner not lighting, holding flame, staying alight or flame lifting
- Induction Cooktop switched itself off
- Oven displays error F111 when selecting Food Sensor Probe function
- The drawer under induction hob gets hot
- How to calibrate the AEG induction cooktop food sensor probe
In Warranty Service & Repair
Need to arrange a repair technician visit? Repairs under warranty are free of charge and we are here to support you after your warranty has expired. Authorised Technicians and genuine parts for complete peace of mind.